PLC Based Horizontal Plastic Injection Moulding Machine

Description:

Standard Features:

• 5 Point double Toggle clamping system of steel casting with steel link and steel bushes with tempered steel pins


• Hydraulic ejector through plate with multiple ejector cycles through nine strokes


• Multiple point automatic lubricating system


• Clamp closing and clamp opening profile with programmable and independent strokes and speeds


• Low pressure mould protection with high mould safety


• Freely programmable control of max. 2 core pulls and air for the control of max. 1 valve


• Mould opening and clamping in Four stages


• Mould setting gear arrangement by Hydro-motor


• Square tie bar distance with large mould height


• High tensile, hard-chrome platted tie bar


• Electrical interlocks in front and rear safety guards


• Ceramic heater


• High torque hydraulic motor for screw drive


• Automatic suck back system


• Four stage injection and four-stage holding time


• Cold start protection


• Gas-nitride screw barrel with standard L/D Ratio


• Injection movement is actuated by two hydraulic cylinders, for perfect alignment to the clamp unit


• Injection unit sliding on hard-chrome steel treated ground tie bars


• Stainless steel hopper with magnetic grill mounted on a swiveling system


• Injection speed, pressure, and holding time profile on 7 steps


• Proportional valve for pressure and flow control with electronic feedback


• Suction and return oil filter


• The component is easily accessible for maintenance purpose


• Resiliently mounted hydraulic pump


• Sealed oil tank with oil temperature


• 24 Volt DC solenoid valve


• Clamping and injection strokes are monitors by linear transducers


• M C B Control each heating zone


• Star Delta starter for pump motor 200 TO 650T


• Overload protection for pump motor